Copyright © https://mongoose-os.com

Mongoose OS Forum

frame

Mac - Adafruit Huzzah32 not detected.

The Mos IDE doesn’t detect the Huzzah32 connected via usb. I followed the set-up directions given on this page: https://mongoose-os.com/gcp/#t6
Any help would be appreciated.
Thank you.

Comments

  • I'm using Huzzah32 boards with a Mac too and had the same problem when I first started out. The instructions you are following are correct, but you may need to hit the "reset" button on the board and or unplug. Also, if you have a newer MacBook with only USB-C ports and are using an adaptor of dongle, you need to disconnect the dongle right where it plugs into your computer, not at the other end, otherwise I found that that too can cause problems and prevent the board from being detected.

Sign In or Register to comment.