I am having problem using the simple "mos call Config.GetNetworkStatus" command...
I get: "Using port COM7 Access is denided" what should I do?
I guess you're following the tutorial, which is a bit outdated
do mos call Sys.GetInfo
mos call Sys.GetInfo
I am following the tutorial but i'm getting the same error using your "mos call Sys.GetInfo" command too.
Ok, thank you.
Are you sure your device is attached to COM7 port ?
If you can attach an animated screenshot of your installation steps + the error you're seeing, that would be most helpful.
I attached images showing the problem. And yes my wemos D1 mini with esp8266 is attached to COM7.
For installation steps i ran mos.exe and followed the wizard.
Let me check. I think there could be issues with the USB-serial adapter driver used by the wemos board
I was receiving the same thing. It might be you have the mos console open and then tried to open a command prompt and connect too. You have to close the mos console. It wouldn't let you connect twice basically. I know this is an old post so hoping it might help others since I found out why in my case.